hwabrowser.blogg.se

Ampeg cabinet serial numbers
Ampeg cabinet serial numbers







ampeg cabinet serial numbers ampeg cabinet serial numbers

We pioneered Super-Valve Technology in the 1960s and continue to offer the ultimate, top-performance gear to the world’s most demanding bassists. The Classic Series is all about the Ampeg SVT. Modern, lightweight neodymium-based enclosures that deliver massive low end in a package that’s portable, powerful and seriously road-worthy. out of the best possible components, Heritage represents the pinnacle of classic Ampeg tone and styling. One other note: You will probably not be surprised to read that, after all of these years, Warranty is no longer applicable.Designed and assembled in the U.S.A. The V4 Speaker Cabinet is a 4 x 12 x 8 ohm loaded with the original CTS speakers.ĭimensions: Width: 27" Height: 30½" Depth: 14" Weight: ~100lbs I viewed the new old stock Made in USA G-T 7027A as a better replacement choice than other available off-shore tubes. That fourth Magnavox tube was accidentally broken during preparation for the photo shoot. The fourth is a NOS 'Made in USA ' 7027A zero hour Groove Tube. A note about these tubes: Three are original 'Made in USA ' Magnavox tubes. Power Tubes: V5-8: 4 x 7027A 'Made in USA ' Magnavox. The Back Panel : Fuse Holder, AC Utility Outlet, Hum Balance Control, Power Amp In Jack, Pre Amp Out Jack, Reverb Lock, Reverb Footswitch Jack, Extension Speaker Jack, Speaker Jack, Impedance Selector Switch (2, 4, 8 ohms) Bass Tone Control, Reverb, Master Volume and three rocker switches: Standby with orange indicator lamp, Polarity Reverse and On-Off with red indictor lamp. Mid Range with ± 20dB and frequency selector for Lo Mid 250-300Hz, Mid 800-1000Hz and Upper Mid 2500-3000Hz. Channel 2 input jack, Volume Channel ONE, Volume Channel TWO, Sensitivity 1 switch, Sensitivity 2 switch (Each -9 dB, -6 dB, 0 dB), Treble control w/3 position 12 dB attenuate, 0, 12 dB boost switch. The Front Control Panel : Channel 1 input jack. The Power Section : 100 watts RMS from 4 x 7027A Power Tubes This Ampeg V-4 Amplifier, Serial Number 162253 with matching Ampeg 4 x 12 Speaker Cabinet, Serial Number 168305 was built during the Magnavox/Selmer era in Elkhart, Indiana, U.S.A. Unbelievable!!! I would doubt that it has as much as one (1) hour of play-time in all those years! It was delivered to us in August 1979 and has been on display in our store for thirty-five (35) years. as an authorized Ampeg Dealer at the time, this amplifier/speaker set has NEVER been sold. You are looking at our original New Old Stock 1979 Ampeg V-4 Amplifier with matching V-4 Ampeg 4 x 12 Speaker Cabinet. Ampeg V4 Amplifier Set including Speaker CabinetĬlicking on Thumbnail will open larger view.









Ampeg cabinet serial numbers